Document Type

Article

Publication Date

Winter 10-23-2023

Abstract

This article presents the results of an experimental investigation into the effect of process parameters in the precision hard turning of Ti-6Al-4V on chip morphology at both macro and micro levels. It also reports on the control of chip generation to improve chip evacuation and breakability at the macro level by varying the process parameters, namely, feed rate, cutting speed and depth of cut during turning tests. A scanning electron microscope (SEM) was used to examine the chips produced for a better understanding of chip curling mechanisms at the micro level. Surface roughness of the machined specimens was measured to assess the effect of chip evacuation on obtainable surface quality. From the results, it was found that the interaction of process parameters has a significant effect on the control of chip formation. In particular, the interaction of higher cutting speeds and greater depths of cut produced chip entanglement with the workpiece for all values of feed rates. Using relatively higher feed rates with a low depth of cut showed good results for chip breaking when machining at higher cutting speeds. Different chip curling mechanisms were identified from the SEM results. Chip side-curl formation showed different segmentation patterns with an approximately uniform chip thickness along the chip width, while chip up-curl occurred due to variations in chip thickness. Finally, it was found that the tangling of the chip with the workpiece has a significant effect on the final surface quality.

Download

Included in

Manufacturing Commons

Share

COinS